7.3 Characteristic emissivity
In case none of the methods mentioned above help to determine the emissivity you may use the
emissivity table ►Appendix A and Appendix B. These are average values, only. The actual emissivity
of a material depends on the following factors:
• temperature
• measuring angle
• geometry of the surface
• thickness of the material
• constitution of the surface (polished, oxidized, rough, sandblast)
• spectral range of the measurement
• transmissivity (e.g. with thin films)
Figure 36: Adjustment of the emissivity in the software PI Connect (menu Configuration/ Device)
To Next Page
Loading...