Opus OP2 - Additional Bed Set-Up Guide

33
1
1
8
4
2
3
5
6
7
2
34
8
BOLSTERS
ADDITIONAL BED SET-UP
Firstly, position the table top in the position shown above to
form the base section of the additional bed.
Arrange the cushions as shown above. Cushions 5, 6 & 7 are
not required for the additional bed and can be removed.
The two bolster cushions fit into cushion number 2 - where
cushion number 6 would usually sit. Then position cushion 4
to the far left, followed.
.
The seating area inside the OPUS® can be reconfigured to provide an additional bed.
The furniture of the Camper with the inclusion of the table forms the base of the additional bed; the table is reinforced to
provide adequate support for sleeping.
STEP 1
STEP 2
STEP 3
LOUNGE SEATING MOVED TO CREATE ADDITIONAL BED