Opus OP2 - Air Annex Set-Up; Annex Components and Attachment

36
SETTING UP YOUR ANNEX
1 x AIR OPUS Annex
1 x Cross filling tube
2 x AIR Annex side walls
Locate the Annex air transfer valve inside your OPUS. This is the black valve located on your main air beam in the camper on the door-side, just above the window.
Install the Cross Filling Tube by unscrewing the top of the black valve, pushing the grey tube on to the valve and then threading the top of the black valve over the
tube and twisting it on. Thread the end of the Cross Filling Tube through the silver loop hole in the OPUS side wall.
Open the air transfer valve – please note that this will cause your tent to deflate. You can also open the quick release valves to deflate faster. You will need to do this to
attain easy access to the zip line attachment on the front face of your tent
Open up the main section of your annex. Identify the zip & Velcro line which is how your will attach the annex to your main tent and layout lay out your annex with the
two front door sections furthest from the camper.
AIR ANNEX SET-UP
Our recommendation is to then stand between the OPUS and the annex and start zipping at the door side, walking backwards between the OPUS and the annex as
you close the zip. This will assist in locating both the Cross Filling Tube that you installed on the main OPUS tent as well as the receiving valve on the annex-side about
half-way along the zip line. The receiving valve is located on the central air pole of your annex.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
2 x AIR Annex doors
1 x AIR Annex Ground Sheet
1 x Patch kit
ANNEX COMPONENTS
36