How to pack and unpack your Alexandria turntable
- remove the inner box by lifting it straight up and out. Open the flaps on both ends of the
inner box and slide out the styrofoam packaging assembly.
- Remove the straps binding the packaging assembly together.
- select a clean, flat work surface, lie a table or counter top for setting up the turntable
Note 1. Your Alexandria packaging has an important role to fulfil
- The front piece is designed to stabilize the platter and the forward movement of the plinth.
The rear piece on top of stabilizing the platter contains the accessories, the record clamp,
the power supply, the tool kit, the drive belt and the oil. It also stabilizes the plinth from
moving back in the packaging.
- the side pieces support the dust cover and stabilize the turntable against vertical and
lateral movement.
The unpackaging procedure must be as follow
- remove the dust cover
- remove the front piece of the packaging
- remove the rear piece with all accessories secured and set is aside
- remove the platter by sliding it our from the front of the turntable
- standing in front, lift the turntable from underneath with your right hand the left side piece
of the packaging and push it out toward the rear.
- Repeat the operation on the right side.
To pack your Alexandria, repeat the above procedure in a reverse sequence. Do not forget to
protect the plinth side edges with polyethylene wrapper or 2 lawyers of “ plastic wrap” before
sliding the side pieces of the packaging. Failing to do so could result in scratching the delicate
surface of the plinth.
ALEXANDRIA MK III
Owner’s manual
To Next Page
Loading...
Need help?
General
