Using Your MICROS Workstation 8
Positioning Your MICROS Workstation 8
1. Place the Vertical Stand or Low Profile Stand on a flat surface as a table or
desk.
2. Align and insert the Workstation on the docking plate, make sure all of four
hooks securely attach to the mounting holes of Stand.
3. Confirm the Workstation firmly lock on the Stand.
4. To remove the Workstation 8 from the Stand, press the unlock button to
release the Workstation
5. There are two Stands shown below for installing Workstation, mounting
methods are same.
Figure 2-1: Install the MICROS Workstation 8 on Low Profile Stand
Figure 2-2: Positioning the MICROS Workstation 8 to Vertical Stand
To Next Page
Loading...
Need help?
General
