Oracle SUN Fire X4640 - How to Reset the ILOM SP Using the Command-Line Interface

▼
How to Reset the ILOM SP Using the Command-Line
Interface
■
To reset the SP, you need the Reset and Host Control (r) role enabled.
■
After updating the ILOM/BIOS rmware, you must reset the ILOM SP.
Log in to the ILOM CLI.
Type the following command:
-> reset /SP
The ILOM reboots. The command line interface is unavailable while the ILOM reboots.
BeforeYou Begin
1
2
Resetting the SP
Sun Fire X4640 Server Diagnostics Guide • December 2010, Rev A42