Oracle SUN Fire X4640 - Creating a Data Collector Snapshot; How To Create a Snapshot With the ILOM Web Interface

Creating a Data Collec tor Snapshot
The purpose of the ILOM Service Snapshot utility is to collect data for use by Sun Services
personnel to diagnose system problems. Customers should not run this utility unless requested
to do so by Sun Services.
This section contains the following procedures:
■
“How To Create a Snapshot With the ILOM Web Interface” on page 37
■
“How To Create a Snapshot With the ILOM Command-Line Interface” on page 39
▼
HowTo Create a Snapshot With the ILOM Web
Interface
Caution – Customers should not run this utility unless requested to do so by Sun Services.
To collect SP data using the Service Snapshot utility, you need the Admin (a) role enabled.
Log in to the ILOM web interface.
BeforeYou Begin
1
37