USING YOUR AMPLIFIER
1. SPEAKER OUTPUT
Connect the amplifier to a speaker cabinet of the correct impedance.
2. Make sure that the ON/OFF switch is in the ON position for a minute or two before use. This
will warm up the pre-amp valve ready for use.
3. VOLUME CONTROL
The volume control adjusts the overall output of the amplifier.
4. TONE CONTROL
The tone control adjusts the overall tone of the amplifier from dark to bright.
5. GAIN CONTROL
The gain control adjusts the input gain of the amplifier.
6. PRE-AMP VALVE
The Micro Terror uses 1 x 12AX7 (ECC83) in the pre-amp.
7. PHONES INPUT
This allows headphones to be connected to the Micro Terror and disables speaker outputs
enabling silent practise.
8. AUX IN
Connect an MP3 Player (or similar audio playback device) to the Micro Terror for jamming.
To Next Page
Loading...
