3. VOLUME CONTROL. (Clean channel)
The volume control adjusts the volume of the clean channel.
High levels will overdrive the output stage in a vintage manner!
4. BASS CONTROL. (Clean channel)
The bass control adjusts the bass response of the clean channel. It also decreases midrange
response when turned fully clockwise.
5. TREBLE CONTROL. (Clean channel)
The treble control adjusts the treble response of the clean channel.
These two controls are slightly interactive, creating a wider tonal range!
6. GAIN CONTROL. (Dirty channel)
The gain control adjusts the gain of the dirty channel.
High levels of gain will heavily overdrive the pre-amp and may sometimes be uncontrollable,
especially when used at high volume levels!
7. SHAPE CONTROL. (Dirty channel)
The shape control adjusts between all midrange (zero) to all bass and treble and no midrange
(maximum), on the dirty channel.
8. VOLUME CONTROL. (Dirty channel)
The volume control adjusts the output volume of the dirty channel.
High levels of volume will heavily overdrive the output stage!
9. CHANNEL SWITCH.
The channel switch switches between the clean and dirty channel.
This switch needs to be switched to the dirty channel in order for the footswitch to function!
To Next Page
Loading...
