Need help?Do you have a question about the ORANGE CR60C and is the answer not in the manual?
General| Power Output | 60 Watts |
|---|---|
| Speaker | 1 x 12" Voice of the World |
| Channels | 2 (Clean and Dirty) |
| Effects | Reverb |
| Footswitch | Optional (for channel switching) |
| Technology | Solid State |
| Effects Loop | No |
| Controls | Gain, Bass, Middle, Treble, Volume, Reverb |
| Inputs | 1 x 1/4" |
| Outputs | 1 x 1/4" |
| Type | Combo |
Explains the lightning flash symbol indicating dangerous voltage and its purpose.
Explains the exclamation point symbol for important operating instructions and potential hazards.
Lists crucial safety practices for amplifier operation, maintenance, and environmental considerations.
Details the amplifier's conformity to UL, CSA, IEC, and FCC standards and regulations.
Instructions for setting the mains voltage selector and replacing the fuse for regional compatibility.
Lists the correct fuse ratings required for 100v, 120v, and 230v mains voltage operation.
Provides step-by-step guidance on how to lift the amplifier safely to prevent injury.
Specifies the minimum impedance requirement for connected speaker loads to prevent damage.
The primary socket for connecting your musical instrument to the amplifier.
Details the Volume, Bass, and Treble controls specific to the clean channel.
Details the Gain, Bass, and Middle controls for the dirty channel.
Describes the Treble and Volume controls for the dirty channel.
Explains the Reverb Selector Switch and Master Reverb Control.
Details the Master Volume control and the Channel Switch for selecting amplifier modes.
The switch used to turn the amplifier's mains power on and off.
Connectors for linking external speaker cabinets to the amplifier.
Sockets for connecting footswitches to control channel and reverb functions.
Ports for integrating external effects pedals or rack units into the signal chain.
To Next Page