Need help?Do you have a question about the OrangeRx TX6i and is the answer not in the manual?
General| Frequency Range | 2.4GHz |
|---|---|
| Channels | 6 |
| Compatibility | DSM2/DSMX |
| Low Voltage Warning | Yes |
| DSC Port | Yes |
| Size | 190 x 80 x 240mm |
| Model Type | Airplane/Helicopter |
| RF Power | <100mW |
| Power Supply | 4x AA batteries (not included) |
Explains safety symbols and their meanings for user protection during operation.
Provides essential guidelines for safe operation and usage of the radio control system.
Details how to install and remove the AA alkaline dry cell batteries from the transmitter.
Explains how to reverse servo direction for each of the 6 channels for proper control.
Allows setting low and high travel limits for servos on all channels for optimal performance.
Adjusts the center position of each servo on the 6 channels for fine-tuning.
Adjusts sensitivity and linearity of stick/knob inputs for channels 1, 2, and 4.
Counts time based on throttle value exceeding a set threshold for flight monitoring.
Offers up, down, or down-then-up timer modes, enabled/reset by switches.
Allows selection of up to 3 sensors to display their values on the main screen.
Configures connected sensors like RX, Battery, Temp, Current, RPM for data display and alarms.
Allows selection of a saved model from memory slots for use.
Changes the model type between airplane, glider, helicopter, and multicopter.
Enables changing the name of a saved model using character selection.
Resets models to factory defaults or copies models between memory slots.
Adjusts helicopter's aileron, elevator, and pitch mixes for desired maneuverability.
Adjusts gyro sensitivity for helicopter stability and responsiveness.
Allows setting a custom username for the transmitter system.
Enables connecting two transmitters for instructor-student flight training.
Displays the currently installed firmware version of the transmitter.
Guides users through downloading and installing the latest system firmware.
Shows the installed RF module version for the receiver.
To Next Page
