6. Install
Insert new HEPA lter with
rubber seal facing in and handle
facing out. Twist the handle
slightly to make sure lter is
fully seated in the housing.
7. Reassemble
Place air purier base back on
the housing. Line up arrow on
housing with the arrow of the
base (near the “Close”). Turn
the base of the air purier
clockwise to tighten until the
arrow on the base is lined up
with the line near “Open”.
8. Lock
Move slide switch left to lock.
9. Reset
Press and hold Filter Reset
button beneath the ashing
light for a few seconds.
Light will turn o when
lter counter is reset.
09
MAINTENANCE
5
3
9
To Next Page
Loading...
