4
EN
- vibration and excessive mechanical stress,
- insects, animals and plants,
- aggressive and chemical substances.
• The operating environment of the device must always be in accordance with the
basic characteristics set out.
• Features of the operating environment:
1. Ambient temperature: +5 ÷ +40 ° C
2. Humidity: 5 ÷ 85%
3. Altitude: ≤ 2 000 m
4. Occurrence of water: intermittent condensation of water or occurrence of water
vapor
5. Occurrence of foreign bodies: quantity and type of dust are insignificant
6. Protection degree: min. IP20 (device protected from touching dangerous parts by
hand and non-waterproof)
• This degree of protection is not indicated on the product and on the technical
parameters in the operating instructions.
• If the protection class of the product is different from IPX0, this information is then
displayed on the label of the appliance or in the technical data of the operating
instructions.
• Other characteristics of the domestic operating environment (mechanical stress
- vibrations and vibrations, occurrence of plant, animals, weather effects ...) are
negligible in terms of effect on the correct and safe use of electrical equipment.
1.3 Electrical safety
• Before connecting the appliance to the power supply for the first time, make sure
that the voltage on the appliance label corresponds to that of the household
electrical outlet.
• The electric appliance is designed to power from 1 / N / PE ~ 230 V 50 Hz.
• The electrical safety of the appliance is guaranteed only if it is properly connected
to the mains.
• Electrical protection class I equipment is equipped with a protection against
electric shock by means of protective earthing of inanimate parts, which can
become dangerous when the device is malfunctioning. Always connect such
devices to properly installed mains sockets that are equipped with earthing
conductors and have a properly grounded earthing conductor.
All electrical equipment is equipped with a three-wire power supply.
• Class II electrical equipment is protected against electric shock by double
insulation or by enhanced insulation of hazardous live electrical parts. Device
of protection class II it must not be equipped with means to connect protective
earthing.
All electrical equipment is equipped with two-wire power supply.
• Class III electrical equipment is a device that is powered by a small safe voltage
source (battery or accumulator) and does not present any danger to the user
from electrical shock.
• In order to provide increased safety against the risk of electric shock due to the
use of electrical appliances by laypersons, it is recommended to install the power
supply circuit for sockets with a rated current not exceeding 20 A RCD with a
rated operating current not exceeding 30 mA.
To ensure the safety and correctness of the electrical installation, consult a
qualified electrician.
• Only use a power cord with a plug (mains lead) supplied with the device and
compatible with a wall socket. Using another cable may result in fire or electric
shock.
To Next Page