Orava RR-71 - Inserting the Battery into the Remote Control

14
EN
Inserting the battery into the remote control
The system can be operated with the supplied remote control. Slide out the battery holder
on the bottom of the remote control.
Insert one 3V battery (type CR2025) into the battery holder according to the correct
polarity + and -. Push the battery holder back into the remote control.
When using the remote control, point it at the sensor to receive signals from the remote
control on the system.
Notes
• Do not leave the remote control in very hot or humid places.
• Do not use a new battery with an old one.
• Make sure that no object enters the remote control, especially when replacing the
batteries.
• Do not place the device so that the remote sensor is exposed to direct sunlight or light
from lamps. Otherwise, it may occur to malfunctions when controlled by remote control.
• If you will not be using the remote control for a long time, remove the batteries to prevent
possible battery leakage and subsequent corrosion.
• After unpacking the remote control, pull out the battery lock clastic.