To Next Page

To Previous Page

A-6

OPTIMOD-AM 9200 VERSION 3.0 SOFTWARE ADDENDUM

lowed, but spaces at the beginning of the passcode string can be used to dis-

able passcode protection (see below).

Press the Next button. Then turn the knob to program the next number in the pass-

code.

F) Repeat step (E) to program the passcode with up to eight numbers.

G) When you have finished programming your passcode, press the SAVE PASSCODE

soft button to save it. Write your passcode down and keep it in a safe place.

2. Program local lockout.

SET MODEM

INIT

REMOTE

INTERFACE

SET

PASSCODE

LOCKOUT

Off

Hold down the LOCKOUT soft button and turn the knob to enable/disable

lockout and set the lockout delay time.

You can program the lockout delay time (in minutes or hours) from 5 min-

utes to 8 hours, or off. This is time delay between the last access to a local

front panel control and when the front panel automatically locks itself out,

requiring entering the passcode to re-establish communication with the

9200.

Unlocking the 9200

The 9200 front panel controls are locked out when the Enter Passcode soft button

is displayed.

On air: xxx ENTER

PASSCODE

To unlock the 9200:

A) Press the ENTER PASSCODE soft button.

Select character with knob ENTER

PASSCODE

Turn the knob until the desired number appears.

C) Press the Next button. Then turn the knob to enter in the next number of the pass-

code, if necessary.

D) Repeat step (C) to enter any additional numbers into the passcode, as necessary.

E) When you have finished entering your passcode, press the ENTER PASSCODE

soft button to unlock the front panel controls.

Orban Optimod-AM 9200 User Manual

Questions and Answers: