FDR 55
16
- Only use the original baskets; forcing the basket into the oil container may create a risk upon removing it
when finished.
- If you do not use the fryer for long periods of time, we recommend applying a thin layer of oil over the
complete surface, even on the resistor and sensor.
- Do not use margarine, butter or lard. They are not suitable for frying since they emit smoke at low
temperatures.
- If overheated, the safety system turns the device off. In order to restart it, unplug the unit and wait until
it cools. Once cooled, re-plug it in and press the "RESET" button on the back of the heating unit. To do
so you will need a thin and long tool.
Cleaning
• Before cleaning, make sure that the device is unplugged and the oil is cooled down.
• If you need to move the deep fryer, use the handles, never the basket or the panel.
• For cleaning do not use aggressive products or metal sponges that can damage stainless surfaces.
Be sure to dry all items before reassembling.
• BASKETS:
- After each use, take out the baskets and soak them in soapy water for 20 minutes. Then use a
scourer.
• HEATING ELEMENTS:
- Remember that the heating elements cannot be soaked into water. Clean it with a wet cloth
and make sure to dry it after cleaning.
- Don’t damage the heating element and the sensor, since it would affect the performance of
the device. As well, it would be dangerous.
• OIL BASKET:
- Take it out very carefully.
- Soak them in soapy water for 20 minutes.
- Then, use a non-abrasive detergent and a soft scourer.
• Assemble the unit again and insert the oil if you want to.
• In case that you will not use the device for a long period of time, store it in a dry, well ventilated and
moisture free place.
SERVICE AND CUSTOMER CARE
If you experience any problems with the operation of the fryer, before calling for assistance refer to the
troubleshooting guide.
To Next Page
Loading...
