FDR 80
BEFORE USING FOR THE FIRST TIME
1. Remove all packaging.
2. Dismantle: see ‘to dismantle, assemble and use your fryer’.
3. Wash the parts: see ‘cleaning’.
PARTS LIST
1. Safety switch
2. Thermostat
3. Heat lamp (Red)
4. Voltage lamp (Green)
5. Lid
6. Oil container (inside, detachable)
7. Frying metal basket
8. Structure
9. Reset button
10. Compartment cable
TO DISMANTLE, ASSEMBLE AND USE YOUR FRYER
To dismantle
1. Lift lid off.
2. Remove the basket.
To assemble and use
1.- If the heating unit is not properly placed, the safety switch can not be pressed, and the appliance
will not operate.
2.- Connect the plug to the mains and a green light will turn on the heating unit. This will remain on
while the appliance is connected to the mains.
3.- Select the frying temperature by turning the knob clockwise. A red light will turn on in the
heating unit. Make sure that the cover is not on.
4.- After a few minutes of heating, the red light will turn off, signalling that the basket can be
inserted with the food to fry. Be extremely careful: dangerous splashes of oil may fly out.
To Next Page
Loading...
