will allow you to water the stations in Program A for their
pre-set durations. Press ENTER to begin watering.
• Or, press NEXT again for MANUAL - PROG B watering. This
will allow you to water the stations in Program B for their
pre-set durations. Press ENTER to begin watering.
To advance to the next station in manual mode, press NEXT.
Press CANCEL to stop the manual watering cycle.
To Set Water Budgeting:
Water Budgeting is a quick way to adjust your set durations
(10 to 200%) based on seasonal requirements.
• Press BUDGET.
• Press or to select the desired budget percentage.
Press ENTER.
Note: If your set duration is 10 minutes and you set the water budget
to 150% the duration will be 15 minutes. If you set it to 50% the
duration will be 5 minutes.
WIRELESS SENSOR STATE
[OPTIONAL FOR RF MODEL ONLY]:
This timer can communicate with Orbit wireless sensors.
To change the communication status between the timer and the
wireless sensor do the following:
• Press the BUDGET button on the Home/Auto Screen.
• Press the SENSOR button on the top right of the screen.
• Use the or to toggle the sensor communication status.
Sensor Active - timer will allow sensor to block watering.
Sensor Bypass - timer will ignore the sensor and will not allow
watering to be blocked.
• Press ENTER when desired status is selected.
To Lock Programming Keys:
• Push the HOME/LOCK button once from the Home screen.
The lock icon, , will show on the screen. To unlock the
touch screen press the HOME button again.
To Prevent Watering:
• To stop watering for a set period (1 to 99 days) press RAIN
DELAY once and select the desired delay using or
and then press START. To cancel the RAIN DELAY and return
to AUTO mode press CANCEL.
• To stop all watering indefinitely, push the RAIN DELAY/
SYSTEM OFF button twice. The controller will be placed
in OFF mode. To return to AUTO mode press the
HOME/LOCK button.
07WTM004225 57932-24 rE.indd 7 5/2/07 4:39:24 PM
To Next Page
Loading...
