Orbit DripMaster Vegetable Garden Soaker System User Manual

VEGETABLE GARDEN
SOAKER SYSTEM
STEP-BY-STEP GUIDE
This expandable Vegetable Garden Soaker System is also ideal for
general landscape watering. To expand your system, simply purchase
additional kits and connect them together or purchase additional tubing
and fittings separately. Up to 35 soaker lines can run off one 1/2”
distribution tube.
PN 67527-24 Rev B
Orbit
®
Irrigation Products, Inc.
North Salt Lake, UT 84054 USA
www.orbitonline.com | 1-800-488-6156
Printed in USA
© 2008 Orbit Irrigation Products, Inc.
All rights reserved. All trade names are registered
trademarks of respective manufacturers listed.
KIT CONTENTS
1 3-in-1 faucet adapter—pressure
regulator, filter and 1/2” drip tube
adapter
5 1/2” tubing hold down stake
1 1/2” tubing end cap
12 4 gallons per hour flag dripper
1 hole punch
50’ 1/4” soaker tubing
24 1/4” tubing hold down stake
12 1/4” tubing end plug
1 pipe thread to hose thread adapter
*Note: 1/2” distribution tubing is not included in this kit. Be sure to purchase/use
1/2” distribution tubing with an outside diameter of .690 or larger.

Orbit DripMaster Vegetable Garden Soaker System Specifications

General

Brand	Orbit
Model	DripMaster
Operating Pressure	25 PSI
Fittings Included	Yes
Length	50 feet
Connection Type	Hose Thread
Application/Usage	Vegetable Garden

Summary

Vegetable Garden Soaker System Overview

Kit Contents

Lists all components included in the soaker system kit for installation.

Soaker System Installation and Tips

Tips for Successful Soaker Layout

Guidance on positioning soaker tubing for optimal water distribution on level ground or around plants.

Step 1: Faucet Adapter and Tubing Connection

Attach the 3-in-1 faucet adapter and connect the 1/2" distribution tubing.

Step 2: Distribution Tubing Layout

Roll out and secure the 1/2" distribution tubing using stakes.

Step 3: Cap Distribution Line

Secure the end of the 1/2" distribution line with the provided end fitting.

Step 4: Insert Dripper

Punch a hole in the distribution line and insert the flag dripper.

Step 5: Connect and Run Soaker Tubing

Attach 1/4" soaker tubing to the dripper and run it along plants, securing with stakes.

Step 6: Flush System

Remove the end cap and flush water through the system for one minute.

Step 7: Finalize System

Reinstall the end cap and insert 1/4" end plugs at the end of each soaker line.