6
ASSEMBLY INSTRUCTIONS
NOTE: Be careful not to damage the PULSE SENSOR WIRES(73,74) while doing assembly STEP 9
to STEP 10.
STEP 9:
a. NOTE: 4pcs BUTTON HEAD BOLTS(M8x12mm)(114) will already be
pre-attached on the SEAT HANDRAIL(70).
b. Remove 4pcs BUTTON HEAD BOLTS(M8x12mm)(114) from the SEAT
HANDRAIL(70).
c. Attach the SEAT HANDRAIL(70) onto the SEAT CARRIAGE(64) with 4pcs BUTTON HEAD
BOLTS(M8x12mm)(114).
STEP 10: Attach the SEAT(68) onto the SEAT CARRIAGE(64) with 4pcs BOLT, ROUND HEAD
(M6x1x15mm)(95). Attach the BACK CUSHION(69) onto the SEAT CARRIAGE(64) with
4pcs HEX HEAD BOLTS (M6x1x30mm)(96).
STEP 11:
a. Turn the knob of the SPRING PIN(67) counter-clockwise and lock the knob in the release position,
refer to the inset drawing.
b. Slide the SEAT CARRIAGE ASSEMBLY(64) onto the RAIL(52). Press the RAIL CAP(55) into the
back end of the RAIL(52).
c. NOTE: 1pcs STOPPER BOLT(54) and 1pcs STOPPER(53) will already be
pre-attached at the end of the RAIL (52).
d. Remove 1pcs STOPPER BOLT(54) and 1pcs STOPPER(53) from the end of
the RAIL (52).
e. Insert the STOPPER BOLT(54) through the RAIL(52) and RAIL CAP(55) to bolt
them together with the STOPPER(53). Please verify that the other STOPPER
BOLT(54) at the front end of RAIL(52) was assembled at the factory.
To Next Page
Loading...
