7
ASSEMBLY INSTRUCTIONS
NOTE:
a. The RIGHT PEDAL(41)
has R decal stamped
on the end of the right
pedal shaft. The
RIGHT PEDAL(41) has
right hand threads and
is tightened by turning
clockwise.
b. The LEFT PEDAL(39)
has L decal stamped
on the end of the left
pedal shaft. The LEFT
PEDAL(39) has left
hand threads and is
tightened by turning
counter-clockwise.
STEP 12:
a. Thread the RIGHT PEDAL(41) onto the RIGHT CRANK(37) located at inside of the CRANK COVER(35) as
the photo shown. Tighten the pedal securely.
b. Select the RIGHT PEDAL STRAP(42) which has R decal marked on the bottom side of the strap. Snap the
three hole end onto the inside edge of the RIGHT PEDAL(41). Snap the other end onto the outside edge of
the RIGHT PEDAL(41) with the R decal mark on the bottom of the RIGHT PEDAL STRAP(42). Select
adjustment holes which allow your foot to be easily removed from the pedals. Do the same way on the left
side.
STEP 13: Refer to the upper inset drawing. Plug the PULSE SENSOR WIRE(73) into the preset socket of the
PULSE COIL WIRE(74) located on the SEAT CARRIAGE(64). Plug the PULSE COIL WIRE(74) into
the preset socket of PULSE CONNECTION WIRE(75) located on the bracket on the MAIN
FRAME(1).
STEP 14: Refer to the lower inset drawing. Connect the ADAPTER(119) to the connector located on the base
of the Main Frame(1). Plug the ADAPTER(119) into an electrical outlet.
STEP 15:
a. A bottle of silicone is packed together with user’s manual.
b. Gently apply the silicone to the rollers sliding path
(inner upper side and inner bottom side) on the aluminum rail.
Note: Apply liberally but be cautious not to spill the lubricant as
applied surfaces will become very slippery. To clean spills use
warm soapy water, repeat if necessary.
c. Then slowly slide the Seat forward and backward for a few seconds
allowing the lubricant spread evenly on the rollers sliding path on
aluminum rail.
Lubricate the silicone to
the rollers sliding path on
the aluminum rail.
To Next Page
Loading...
