Orbit ORBITF3400 - Using the Remote Control

Page 4 / 16
USING THE REMOTE CONTROL
The remote starter is equipped with two remotes 2-way 4-button multi-channel remote control .
COMMAND
TIME
PRES-
SED
COMMAND CONFIRMA-
TION
DESCRIPTION
LOCK
0,5
SEC.
1beep
Locks all doors, arm the anti-theft
system and activates the Alarm (if
installed). Press LOCK for 3 seconds
to activate the Panic Mode
1 Green Flash
UNLOCK
0,5
SEC.
2 beeps
Unlocks all doors, disarms the
anti-theft system and deactivates the
Alarm (if installed).
2 Green Flash
START
3
SEC.
Ascending notes [2]
Remote-start the vehicle. Press
START again to reset the runtime.
(See: remote-starter features,
page 7)
2 Green Flash
TRUNK
(FUNCTION)
3
SEC.
1 beep
Opens the trunk, and deactivates
the Alarm (if installed). The Alarm
ignores the trunk zone until it is
closed.
1 Green Flash
2X
The status of the remote-starters
or alarm system can be queried via
remote control
STATUS
REQUEST
Press 2
times
FUNCTION
0,5
SEC.
1 beep
The vehicle is LOCKed (and ARMed,
if installed).
1 Green Flash
2 beep
The vehicle is UNLOCKed (and
DISARMed, if installed).
2 Green Flash
Ascending notes [2]
The vehicle is running by remote-
start.
2 Green Flash
STOP
0,5
SEC.
Descending notes
[2]
Press and release FUNCTION and
then press START
Remote-Stop.
2 Red Flash
AUXILIARY1
0,5
SEC.
1 beep
Press and release FUNCTION and
then press LOCK
AUXILIARY1 (See: Auxiliary use,
page 10):
1 Green Flash
AUXILIARY2
0,5
SEC.
1 beep
Press and release FUNCTON and
then press UNLOCK
AUXILIARY2 (See: Auxiliary use,
page 10)
1 Green Flash
+
LOCKED THE
REMOTE
Until the RED DEL turn on.
Press simultaneously FUNCTON and
LOCK. See : REMOTE LOCKING
AND UNLOCKING, page
11
UNLOCKED
THE RE-
MOTE
Until the GREEN DEL turn on.
The remote BLUE led turn ON when a button is pressed.
The remote  ash BLUE when the remote is transmitting the informations.
The remote GREEN led turn ON when the vehicle succesfully received the command.
After 5 sec. of transmission , if the command failed the remote RED led turn ON and a low beep
will sound.
NOTE [1]: It is possible that the remote control was able to communicate with the remote-starter and that action was
performed successfully, but the remote-starter was unable to send its response back to the remote control. Some
factors such as radio interference may interfere with the communication between the remote control and the remote-
starter. See the TRANSMITTER RANGE page 13 and FAILED REMOTE-START page 14
NOTE [2]: The response from the remote-starter may take up to 8 seconds or longer (diesel mode).