Total running hours vs lubrication frequency:
ALIGN AND TIGHTEN THE RUNNING BELT
ALIGN THE BELT: If belt has moved to left, start
treadmill at 3kph .Use
6mm Wrench
to turn the fixed left
bolt clockwise or turn the fixed right bolt
counterclockwise by a quarter circle. Wait for at least
30 seconds for belt to align. If necessary, turn another
quarter circle until the belt is aligned. Do not over tighten
as it may damage the belt.
TIGHTEN THE BELT: If running belt slips when
walking or running, it means that belt is too loose. Start
treadmill at 3kph.Use
6mm Wrench
, turn both bolts 1/4
clockwise. Test and see if it fixes the problem or turn
another ¼ circle. When running belt is properly tight to
walk on, you should be able to pull up each side of the
belt 5 to 7 cm off the platform. Be careful not to over
tight. If problem persists, call distributor for advice.
CLEANING: Don't use abrasive products. A warm damp cloth is good.
LEVELING: If equipped, adjust foot pads to level treadmill on an uneven surface.
Otherwise, use floor mats to support it in leveling.
如果跑带左偏,则顺时针调节左
边螺丝或逆时针调节右边螺丝
如果跑带右偏,则顺时针调节右
边螺丝或逆时针调节左边螺丝
If deviate to the right, then
adjust the screw on the right side
clockwise or the screw on the left
side anticlockwise.
If deviate to the left, then
adjust the screw on the left side
clockwise or the screw on the
right side anticlockwise.
if the running belt slips,use 6mm wrench,turn both sides
bolts 1/4 clockwise.Repeat this procedure until the belt is
properly tightened.
To Next Page
Loading...
