EasyManuals Logo

Orbit Starlite SL3 User Manual

Orbit Starlite SL3
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
9
VI. MAINTENANCE
If power cord is damaged, it must be replaced by a qualified
electrician or a service technician from the distributor.
DO NOT TANGLE THE POWER CORD
REGULAR MAINTENANCE OF THE TREADMILL
STORAGE: Keep your treadmill indoor in stand-up position, away from dust
and moisture. Don’t store it in an open space where it might be exposed to
weather. Moisture, dust and water could cause rust to metal parts and damage
to electronics. This would void its product warranty.
POWER CORD: Exam power cord regularly. Make sure it’s intact. Pets bite
may damage cable and cause dangerous leakage. Have it replaced when
damaged.
SCREWS AND CONNECTING CABLES: Exam and tighten screws on a regular
basis, because screws and nuts may come loose due to vibration. Take care not
to damage cables in folding up and down the treadmill.
LUBRICATION: Always clean running deck and running belt before
lubrication.
a) Switch off power and detach power cord from power supply.
b) Lift running belt and insert the lubricant pot as deep as possible under the
belt. Apply lubricant oil onto middle of running deck. Do it from both sides
of treadmill, covering areas about 15cm from motor cover to about 30cm
from rear roller.
c) After lubrication, leave the treadmill running at 1km/h for at least 5
minutes to spread silicon oil evenly on running deck.
d) Please refer to below table as guide line on lubrication frequency.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Orbit Starlite SL3 and is the answer not in the manual?

Orbit Starlite SL3 Specifications

General IconGeneral
BrandOrbit
ModelStarlite SL3
CategoryTreadmill
LanguageEnglish

Related product manuals