ORBITEC OXY- SMART - Filter Status and Replacement; Filter Status and Error Messages

To Next Page

To Previous Page

Instruction Manual OXY- SMART

9. Filter status

The sensor requires a minimum quantity of measuring gas in order to perform an

exact measurement. If this quantity is not reached, a higher or completely useless

measuring result is to be expected.

A used or obstructed filter may be the cause of this.

The measuring device can read the filter capacity (use - wear) and indicates the

result by means of an error message on the display:

In case of such a warning, please replace the filter and examine if the tube or the

hose kit are damaged or if foreign particles have been sucked in. In case of doubt,

replace the whole hose set incl. the tube. Please only use the filters prescribed by

ORBITEC GmbH.

Designation

Item No.

Illustration

Complete hose

kit

Item No.: 1.3.5016

Filter

Item No.: 1.3.5015

Cannula

Item No.: 1.3.5020

Spare hose 1m

Item No.: 1.3.5019

Øa-7mm Øi-4mm L-1000mm Mat.: PVC