Charging the Battery
It is recommended to charge the new battery before using the electric
saw for the first time. Insert the output plug of the battery charger into
the chargingsocket of the battery, and then plug the charger into the
power outlet. The LED indicator on the charger will turn red during the
charging process and will turn green when the battery is fully charged.
It takes about 2 hours to fully charge the battery.
Indicator Light
Red
Green
Status
Charging
Full Charged
After the battery is fully charged remove the charger plug from the
outlet and remove the battery from the charger.
1. It is normal that the battery and charger heat up during charging.
2. It is recommended to charge the battery every 3 months during
long-term storage to perserve the full life-time of the battery.
3. It takes approximately 5 charging-discharging cycles to reach the
full capacity of a new or stored battery.
4. Please do NOT charge the fully-charged battery again after a few
minutes of use. This can potentially reduce the lifetime and efficiency
of the battery.
5. Please do NOT use damaged batteries, disassemble the charger
or the battery.
6. Do NOT charge the battery outdoor or in a humid environment.
7. When the battery is low, the cutting strength of the electric saw
will decrease, which is normal.
8. Do NOT store the battery in a humid environment.
EN.03
Battery Charging Jack
Lithium Battery Charger
To Next Page
Loading...
Need help?
General
