Orcam READ - Time and Date Settings; Setting Zone and Time

● “Read the article about ‘X’”
○ After reading the headlines, speaking this command will have OrCam Read find
and read the article that contains the word you spoke.
○ Note: “X” is a placeholder for the word you are searching.
● “Restart”
○ Use this command to restart the Smart Reading feature whenever you want to
re-scan the current page or scan a new page instead of manually exiting and
re-entering the feature.
● “Volume Up”
○ OrCam Read will raise the device’s volume one level.
● “Volume Down”
○ OrCam Read will lower the device’s volume one level.
● “Reading Speed Up”
○ OrCam Read will now speak and read faster at a faster rate.
● “Reading Speed Down”
○ OrCam Read will now speak and read slower at a slower rate.
● “Exit”
○ This command will have OrCam Read exit the Smart Reading feature.
Set Zone and Time.
There are three ways to set the internal clock of your device:
● Go to the Time Set page on the website: www.orcam.com/timeset. Press the trigger
button to read the “OrCam Please Set Zone and Time” command on the screen.
● Set the time manually through the audio settings menu.
● The time will automatically be set or updated when your device is connected to WiFi.
Tell the Time and Date.
● There are two ways to hear the current time:
○ Rapidly press the trigger button twice and say after the long beep, “Tell the time”.
○ Use the mouse laser pointer to read the following command:
OrCam Please Tell Time
● There are two ways to hear the day of the week and the date:
○ Rapidly press the trigger button twice and say after the long beep, “Tell the date”.
○ Use the mouse laser pointer to read the following command:
OrCam Please Tell Date
● After a few seconds, OrCam Read will announce the current time and/or date.