6
UNIT DOES NOT TURN
ON
UNIT DOES NOT
REMOVE POLLUTANTS
UNIT SPARKS,
CRACKLES AND POPS
UNIT DOES NOT
REMOVE ODOR
UNIT STILL DOES NOT
OPERATE PROPERLY
1. Power Cord
2. Selector Switch
3. Front Grill
Ionizer/Electronic
Collector Cell
Ionizer/Electronic
Collector Cell
Old Charcoal Odor
Absorber
Check all the above
points
1. Plug in power cord
2. Set selector switch
for desired fan
speed.
3. Reinsert front grill
until it is flush with
cabinet front. Tap
grill lightly, if
necessary, to fully
insert.
Wash Collector Cell.
Make sure it is
thoroughly clean & dry
before re-installing it.
1. Sparking or
popping noise
occurs when a
large particle is
captured in the
Collector Cell.
2. If the unit is arcing
excessively, the
Collector Cell may
be dirty. Try cleaning
the Collector Cell.
3. If excessive
arcing continues
after proper cleaning,
the Collector Cell
may be damaged.
Return unit to the
Service Center.
Replace Charcoal
Odor Absorber.
Return unit to the
Service Center.
ALL OTHER SERVICING SHOULD BE DONE BY AN
ORECK AUTHORIZED SERVICE CENTER.
PROBLEM CHECK WHAT TO DO
Troubleshooting Guide
Service problems that appear to be major can often be solved
easily. You can be your own troubleshooter by reviewing the
chart below. It pinpoints problems and how to correct them.
Remember, check the simple things first.
To Next Page
Loading...
Need help?
General
