5
ENGLISH
Operation
continued
Assembling the Handle
Align the four connector tabs at the
bottom of the magnesium handle with the
four receiving ports at the top of the outer
bag and insert until a “snap” is heard.
Snap cord assembly into the cord clip
located on the back of the magnesium
handle. Leave excess cord at the power
head to allow movement.
Operating the Oreck Magnesium
™
Make sure the disposable inner bag is in place. Do not operate
the vacuum without a disposable inner bag. Plug the power cord
into an electrical outlet and press the ON/OFF switch on the back
of the vacuum when ready to operate. Press the button once to
turn the unit on high, press a second time for low speed, and a
third time to turn the unit off.
1
2
4
5
6
3
Cord Clip
2
3
Up-Position Lock - Place foot on power head
and lean handle back gently to release lock for
vacuum use. Return handle to the full upright
position to engage lock.
Note: Do not operate the vacuum while in
the upright and locked position. Do not let
the vacuum run while in any one stationary
position for any period of time. Keep the
vacuum moving while in operation.
Cord Dump - To release cord, twist cord dump 1/2
turn. Slide cord off cord dump.
Easy Power Cord Storage -Turn Cord Dump to
the up position, wrap power cord around Cord
Dump and lower cord bracket located below
the Carry handle.
Carry Handle - Carry handle located on back
of the vacuum for easy lifting, carrying, and
vacuuming stairs.
6
5
4
1
To Next Page
Loading...
Need help?
General
