VI) Quick Start
Battery Installation
Be careful!!
The edge of the base clip is sharp,
when unscrewing the cover, make sure the clip is in
the same direction as the lens. Observe the following
precautions when unscrewing the cover of the camera:
1. Unscrew the cover at the end of the unit.
2. Place your finger on the 'lip', which is on the bottom
half of the rear of the unit, and pull in an upward
direction to open the battery slot door.
3. Insert 2 x AA alkaline batteries into the battery slot
with the polarity in the direction as shown.
4. Close the battery slot door and screw on the end of unit cover.
Important: When the battery is low, the low battery
icon will appear on the LCD display.
Always upload video footage to your PC prior to
replacing batteries to avoid memory loss
Note:
a) Battery installation should be done under adult supervision.
b) Do not mix old and new batteries together. Replace
both batteries at the same time.
c) Remove the batteries if the camera is not going to be
used for long periods of time. This will save battery
life.
11
d) Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries. Only batteries of the same or equivalent
type as recommended are to be used together.
e) Non-rechargeable batteries are not to be recharged.
f) Rechargeable batteries are to be removed from the camera before being
charged.
g) Rechargeable batteries are only to be charged under adult supervision.
h) Exhausted batteries are to be removed from the camera.
i) The supply terminals are not to be short-circuited.
Turning the Camera On
Press and hold the for 2 seconds (two beeping
sounds). The LCD display will light up.
For your safety, do not press any buttons on the camera
during sports activities.
Turning the Camera Off
1. Press and hold the for 2 seconds (two beeping
sounds). The LCD display will turn off.
2. The camera will be turned off automatically after 30
minutes of not being used unless it is in USB mode.
12
To Next Page
Loading...
Need help?
General
