Oregon Scientific ATC9K - MicroSD Card Handling; MicroSD Card Insertion; MicroSD Card Removal; Connecting to a Computer

- 13 -
XII) MicroSD Card Insertion / Removal
Insert
1. Turn the camera off.
2. Unlock the end latch to open the camera.
3. Ensure the microSD card terminals are facing down,
then insert it carefully and completely until it clicks
in place.
4. Close the camera and lock the latch.
Remove
1. Turn the camera off.
2. Unlock the end latch to open the camera.
3. Push the card until it clicks, then pull the card out.
4. Close the camera and lock the latch.
NOTE:
- Ensure the card is inserted correctly.
- Do not touch the connect terminals on the back of the microSD card.
- The card may be damaged if it is not fully inserted.
- The card and the data may be damaged if the microSD card is inserted or removed while
the camera is on.
- Do not touch the at cable as this may seriously affect the camera performance and
functions.
- The camera supports microSD/SDHC Class 4 cards or above and compatible up to
32GB. MicroSD cards with lower classes may cause performance drop during recording.
XIII) Connecting to a Computer
You can upload your recorded video footages and
photos to a PC by connecting the ATC9K to your PC using the PC Application.
You may download the latest version in atc.oregonscientic.com.
1. Turn the ATC9K on.
2. Connect the ATC9K to a PC via the USB cable.
3. The ATC9K will be connected as a USB Mass Stor-
age Device.
4. You can then manage your videos and photos by
launching the PC application.