Oregon Scientific BAR122HGLA - Operation and Usage; Table Stand or Wall Mounting; Reset Button Functionality; Getting Started and Signal Reception

_ LOW BATTERY WARNIN G
When it is time to replace batteries, the low-battery indicator will
be displayed for the selected channel.
HOW TO USE THE TABLE STAND OR WALL
MOUNTING
The main unit has a removable table stand which when connected
can support the unit on a flat surface. Or you can remove the stand
and mount the unit on a wall using the recessed screw hole.
The remote sensor comes with a wall mount holder and a table stand.
Remote unit
Wall-mount
«
O
Table Stand
Main unit
Wall-mount
Table Stand
THE RESET BUTTON
This button is used when the unit is operating in an unfavorable
way or malfunctioning. To return all user programmed settings to
their original factory values, press [ RESET ] by using a blunt
stylus to hold down the button.
_ GETTING STARTE D
Once batteries are placed in a given remote sensor unit, it will start
transmitting information at 40-second intervals.
For approximately a 3-minute duration, the main unit will
automatically search for signals once batteries are installed. Upon
successful reception, the individual channel temperature reading
will be displayed on the second line and the respective humidity
reading on the third line. The main unit will automatically update
its readings at about 40-second intervals.
5