EN
10
REMOTE SENSOR
This product is shipped with the RTGR328N Thermo/
Hygro Sensor and an optional UVR138 Ultraviolet Sun
Ray Sensor (BAR323HGN only). The main unit can collect
data from up to 6 sensors (5 Thermo/Hygro Sensors
and 1 UV Sensor). Additional sensors sold separately.
The RTGR328N Sensor collects temperature and
humidity readings, and signals from official time-keeping
organizations for the radio-controlled clock.
For information about the UVR138, refer to the UVR138
User Manual.
THERMO / HYGRO SENSOR SETUP (RTGR328N)
1. Open the battery compartment with a small Phillips
screwdriver.
2. Insert the batteries.
3. Set the channel and radio signal format. The
switches are located in the battery compartment.
SWITCH
OPTION
Channel
Channel 1 – 5. If you are using
more than one sensor, select a
different channel for each sensor.
EU (DCF) / UK (MSF)
Radio Signal
Format
4. Press RESET. Then set the temperature unit.
5. Close the battery compartment.
6. Secure the sensor with the wall mount or using the
fold-out stand.
FOLD OUT STAND
SWITCH OPTION
Temp °C / °F
BAR321/323HGN English R3 R 3/27/04, 11:25 AM10
Black
To Next Page
Loading...
