3
PAIRING WITH THE WEATHER
+
1. Make sure Bluetooth is turned on. Tap the app icon to open, it shows the Add Device screen.
2. Tap Start Device Search to start searching. Press and hold the Weather
+
for 2 seconds to enter the pairing
mode, the blue light ashes for approximately 30 seconds.
3. The searching screen displays eligible devices for pairing. You may also pull the screen downward to refresh.
Tap your desired Weather
+
under the Eligible Devices, then tap OK to proceed.
Devices available for pairing list
under Eligible Devices section.
Devices that might have been paired
with the smart devices and are not
available for pairing list under the
Ineligible Devices section.
4. Tap the camera icon to choose your desired area. You may choose a photo from Photo Library, Take photo
using the camera, or Use Default Photo from the app. Then press OK to conrm and proceed.
5. Tap the device name to edit.
6. Tap > on the right to choose the room type, then press OK.
To Next Page
Loading...
