5
GB
TEMPERATURE
HUMIDITY
IN/OUT MIN MAX
COMFORT
IN
HOW TO SELECT THE TEMPERATURE
UNITS OF MEASURE
The switch on the back of the Thermo-Hygrometer allows you to
select between degrees Celsius and Fahrenheit. Set the switch to
‘°C’ for selecting Celsius and to ‘°F’ for selecting Fahrenheit.
LOW BATTERY SIGNAL INDICATION
If the voltage of the battery becomes low, the ‘BATT’ indicator will
be display at the top right corner of the display . Replace the
battery when the ‘BATT’ indicator is displayed.
HOW TO REST THE UNIT
If you Thermo-Hygrometer doesn’t operate properly, take out the
battery from the unit for 4 to 5 seconds, then reinstall the battery.
MOUNTING THE OUTDOOR
TEMPERATURE SENSOR PROBE
You can mount the outdoor temperature sensor probe by following
steps :
1. Drive a screw into the wall at the location you choose for the
sensor probe ,to fix the wire attachment to the wall.
2. Route the sensor probe cable through a window .
3. Locate sensor probe into wire attachment.
Note :
Locate the sensor probe away from direct sunlight and heavy
precipitation.
‘°F’ POSITION
‘°C’ POSITION
READING IN °C
READING IN °F
INDOOR
OUTDOOR
OUTDOOR
SENSOR
PROBE
SCREW
WIRE ATTACHMENT
°C
°F
°C
°F
IN
IN
To Next Page
Loading...
