5
GB
HOW TO ENABLE OR DISABLE
AUTO-RECEPTION
If you wish to disable the auto-reception feature while the unit is
within range, switch off the radio hold down the [VOLUME
-
]
button for two second. The [ ] signal will disappear. The unit
will NOT respond to radio signals.
To enable the feature again, hold down the [VOLUME
+ ] button
for two seconds. The [ ] signal will start blinking to initiate
reception automatically.
HOW TO SET THE CALENDAR
CLOCK MANUALLY
When the normal time is displayed,
1. Press [CLOCK] for two seconds.
2. Enter the hours using the [
+ ] and [
-
] buttons. Hold down
either button to rapidly increase or decrease the value.
3. Press [CLOCK].
4. Enter the minutes using the [
+ ] and [
-
] button.
5. Press [CLOCK].
6. Follow the same procedure to set the display language
(English, French, German, Italian and Spanish), year, month,
day and ZONE time.
Press [CLOCK] to save the changes and exit. If changes are made
after the minute adjustment, the seconds will reset and start from
zero.
The unit will also save all changes and return to normal display
automatically after the unit has been left idle for 1 minute.
HOW TO SET THE ALARMS
1. Press [ALARM] to switch to display the alarm setting.
2. Select ALARM 1 or ALARM 2 using [ALARM].
3. Press and hold [ALARM] for two seconds.
4. Use VOLUME [ + ] / [
-
] to enter the hours.
5. Press [ALARM].
6. Use VOLUME [
+ ] / [
-
] to enter the minutes.
7. Press [ALARM].
8. Use VOLUME [
+ ] / [
-
] to select ALARM or RADIO. If
ALARM is selected, a two-minute crescendo alarm will be
emitted at the set time when the alarm is active. If RADIO is
chosen, the radio will be turned on for two hours at the set time
instead.
9. If RADIO is chosen, use [STATION] to choose the radio
station and press [AM / FM] to select AM or FM.
10.Press [ALARM].
11.Use VOLUME [ + ] / [
-
] to set the volume of the wake up radio.
12.Press [ALARM] to exit.
Note: If there is no battery for the radio, there is no operation for
step 9 ~ 11.
To Next Page
Loading...
Need help?
General
