Oregon Scientific RRM320P - Alarm; Set Alarm; Activate;Deactivate Alarm; Silence Alarm

6
E N
The settings order is: time-zone offset, 12/24 hr format,
hour, minute, year, month-day / day-month, day and
month.
Time zone offset sets the clock +/- 23 hours from the
received clock signal time.
ALARM
To set the alarm:
1. Press
SET or SET to display desired set
alarm time.
2. Press and hold
SET or SET to enter
respective setting.
3. Press
+ / - to set hour / minute.
4. Press + / - to select beep alarm
or radio alarm .
5. If radio alarm is selected, press
+ / - to select the
radio station and + / - to adjust the volume.
To activate / deactivate alarm:
• Press
ALARM 1 ON / OFF or ALARM 2
ON / OFF.
To silence the alarm:
• Press SNOOZE / SLEEP to silence it for 8 minutes
OR
• Press
SET / SET , / , to turn the
alarm off and activate it again after 24 hours.
RADIO
To activate / deactivate radio:
• Press
RADIO ON / OFF to turn radio ON / OFF.
To set radio station:
1. Press RADIO ON / OFF or SNOOZE / SLEEP to
enter Radio Mode.
2. Press STATION to scroll through preset station
numbers (1-8).
3. Press and hold TUNE + / TUNE – to auto search
or press TUNE + / TUNE - to manually select
frequency.
4. Once desired frequency has been found, press and
hold STATION to save.
To adjust volume:
• Press VOL + / VOL –
when in Radio Mode.
To adjust sleep timer setting:
1. Press
SNOOZE / SLEEP to activate.
2. Press SNOOZE / SLEEP again to change the sleep
time setting (120, 90, 60, 30, 15, 0 min).
PROJECTION
This unit projects time and outdoor temperature
information for your convenience.
For continuous projection:
• Slide
PROJECTION switch to ON when adaptor is
connected, to enable / disable.