Oregon Scientific WMRS200 - Getting Started: Hub and Data; Set Up USB Communications Hub; Sensor Data Transmission; View Readings on PC

5
E N
To set up the Rain Gauge:
2
1
1. Remove screws and slide the cover off in an
upwards motion.
2. Insert the batteries (2 x UM-3 / AA), matching the
polarities (+ / -). Press RESET after each battery
change.
3
3. Remove the fibre tape.
To ensure a level plane:
Put a few drops of water on the cross at the base of the
funnel to check the horizontal level.
1
23
4
Water will pool to the center of the cross when the rain
gauge is level.
If water remains on 1-4, the gauge is not horizontal.
If necessary, adjust the level using the screw.
NOTE For best results, ensure the base is horizontal
to allow maximum drainage of any collected rain.
GETTING STARTED
SET UP USB COMMUNICATIONS HUB
NOTE Install batteries matching the polarities (+
/ -) in the remote sensors before installing the USB
communications hub.
For continuous use, connect the USB communications
hub to computer using USB cable provided. A
rechargeable battery is included for back-up use only.
NOTE Batteries should not be exposed to excessive
heat such as sunshine or fire.
SENSOR DATA TRANSMISSION
To search for a sensor:
Press and hold
SEARCH located at the back of USB
communications hub.
Icons will flash during search
mode.
Continuous display of icons indicate that the respective
remote sensor has been successfully logged.
NOTE Unit will search only for already registered
sensor or new sensor reset within last 30 minutes. To
register a new sensor, reset sensor prior to search.
TIP The transmission range may vary depending
on many factors. You may need to experiment with
various locations to get the best results.
VIEW READINGS ON PC
To upload records to PC:
Plug USB and upload onto computer.
For your convenience, rechargeable battery will
automatically be charged.
NOTE PC program must be installed before uploading
of records from USB communications hub.
IMPORTANT Ensure sleep mode on computer is
disabled as this will adversely affect the operation of
this unit.
TO DISABLE SLEEP MODE ON PC
1. Right Click on Desktop.
2. Choose Properties.
3. Click on “Screen Saver” Tab in the “Display
Properties” window.
4. Click on “Power” located on bottom half of window.
5. A new window “Power Options Properties” will
open.