Oregon LM300 - Troubleshooting

19
Lawn Mower Model LM300
Transport
Troubleshooting
Troubleshooting
Use this table to see possible solutions for possible problems with the lawn mower. If these suggestions
do not solve the problem, see “Warranty and Service”.
SYMPTOM POSSIBLE CAUSE RECOMMENDED ACTIONS
Tool fails to operate
Possible clogging
Remove battery, remove safety key.
Clear obstructions.
Check underneath the garden product and clear out as
necessary (always wear gardening gloves).
Battery not fully charged Charge battery.
Battery not inserted
(properly)
Properly insert battery.
Grass too long
Increase height of cut and tilt garden product to reduce
starting load.
Motor protector has
activated
Allow motor to cool and increase height of cut.
Battery too hot/cold Allow to cool/warm.
Safety key not inserted
correctly/fully
Insert safety key correctly.
There is a short delay in
the motor starting after
engaging the safety
button switch
Hold safety button for 1 – 3 seconds before engaging
switch lever to start motor.
Motor starts and
stops immediately
Battery not fully charged Charge battery.
Isolator key not inserted
correctly/fully
Insert safety key correctly.
Battery not inserted
(properly)
Properly insert battery.
Battery too hot/cold Allow to cool/warm.
Tool functions
intermittently
Internal wiring of garden
product damaged
Contact service agent.
Motor protector has
activated
Allow motor to cool and increase height of cut.
Garden product
leaves ragged
finish and/or Motor
labours
Height of cut too low Increase height of cut.
Cutting blade dull Replace the blade or sharpen the blade.
Possible clogging
Remove battery, remove safety key.
Check underneath the garden product and clear out as
necessary (always wear gardening gloves).
Blade fitted upside down
Remove battery, remove safety key.
Refit blade correctly.