What to do if Oricom Handsets display 'OUT OF RANGE'?
If your Oricom Handsets display 'OUT OF RANGE', it could be due to a couple of reasons. First, the base station might be too far away. Try reducing the distance between the handset and the base station. Second, the base station might not be properly connected to the mains. Ensure the base station is connected to the power outlet.
Why is there no dialing tone when pressing TALK ON key on Oricom Handsets?
If you don't hear a dialing tone when pressing the TALK ON key on your Oricom Handsets, there might be a few reasons: * The connection cord of the base station may not be plugged in. Check all connections, unplug and plug back in the mains, and ensure the telephone line cord is connected to both the base station and the phone socket. * The adaptor cord may not be correctly plugged into the base station. Check the base station and mains plugs are connected correctly by removing and plugging them back in. * The line may be busy. Wait until the line is free.
What to do if incoming calls are blocked on Oricom Handsets?
If incoming calls are being blocked on your Oricom Handsets, here's what to check: * First, examine if 'BLOCK SET.' is set to 'VIP OK' or 'CONTACTS OK'. If it is, change 'BLOCK SET.' to 'OFF'. * Second, verify if 'BLOCK SET.' is set to 'ON' and whether the incoming call number is on the blocklist. If it is, remove the number from the blocklist. * Turn on answering machine.
What to do if Oricom Handsets have no display?
If your Oricom Handsets have no display, the battery is likely empty. Recharge the battery.
What to do when Oricom Handsets are connected to a PBX, but there is no and/or wrong connection after dialing?
If you experience no or wrong connection after dialing when your Oricom Handsets are connected to a PBX, a dialing prefix might be needed. Insert the appropriate dialing prefix.
Why does recording stop on Oricom Handsets while recording an outgoing message or listening to messages?
If the recording stops while you are recording an outgoing message or listening to messages on your Oricom Handsets, it's probably because you are receiving a call. Answer the incoming call and try again to record your outgoing message later.
General| Number of Handsets | 1 |
|---|---|
| Caller ID | Yes |
| Speakerphone | Yes |
| Hearing Aid Compatible | Yes |
| Answering Machine | Yes |
| Large Buttons | Yes |
| Type | Cordless Phone |
| Frequency | DECT |
| Range | Up to 300 meters outdoors |
| Battery Life | Up to 10 hours talk time / 100 hours standby time |
| Display | LCD |
| Phonebook | 50 entries |
| Visual Ringer | Yes |
To Next Page
