26
Operations
Scan resume time
You can select 5, 10, or 15 sec depending on your selection. SCAN will start
again after a 5, 10, or 15 sec pause even though a signal is still present.
If P5 is selected, SCAN will stop on all channels as long as a signal is
present. It will then resume SCAN again 5 seconds after no transmission
is present.
Auto power OFF
The auto power off function is activated when no transmitting and no
key function is present for the time selected.
The automatic power off time can be adjusted to OFF, 1, 2, or 4 hours in
menu mode.
To Next Page
Loading...
