Origin Effects RevivalDRIVE User Manual

12
Connecting the RevivalDRIVE
INSTR input: Connect to your guitar, bass or other instrument.
AMP output: Connect to your amp, power amp, mixer or recording interface.
9VDC input: Connect a 9VDC 2.1mm centre-negative mains power adaptor.
F/SWITCH input: Connect the optional dual footswitch (sold separately).
SUGGESTED CONNECTION SETTINGS
Plugging into a guitar amp, bass amp or amp modeller:
MODE DIP switch: On the rear of the
pedal, set switch 1 on the MODE DIP switch
to the downward position. No EQ is applied
to the DRY signal or when the
RevivalDRIVE is in bypass.
RE-AMP EQ: Select EQ1 (for brighter
sounding amps) or EQ2 (for darker sounding
amps) on the RE-AMP EQ switch and use
the HI SHELF boost/cut control and BRI-
CAP CUT filter to adjust for the high-
frequency response of your amp.
Note that in the case of the "Custom" model,
switching to the EQ2 setting enables the
FRONT-PANEL FILTER controls, which
offer compatibility with bright and dark
amps alike. Please see FRONT-PANEL
FILTER controls for more information.
Rear connections. Left to right: Instrument input; External Footswitch; Power; Output

Origin Effects RevivalDRIVE Specifications

General

Bypass	True Bypass
Technology	Analog
Inputs	1 x 1/4"
Outputs	1 x 1/4"
Power Source	9V DC power supply (not included)
Input Impedance	1 MΩ
Output Impedance	1 kΩ
Type	Overdrive
Controls	Output, Blend, Highs, Lows, More/Pres, Gain
Channels	Mono