34
-
-
Chamber max speed
Speed of the chamber when lling up with material.
-
Chamber feed speed
Chamber speed during net feeding and cung
-
Chamber net speed
Net wrapping speed
-
Chamber bale out speed
Speed of the chamber when bale is ejected out of the
chamber.
-
Chamber full level
Level of chamber lling when elevator slows down
-
Chamber max pressure
Seng of a maximum pressure inside the chamber at a
point when elevator stops and net/lm starts.
-
Elevator stop delay
Delay of elevator stop aer chamber is full
Feed delay
Delay of net feed
Net feed me
Time necessary during net feeding to get it anchored
(hooked) between chamber and bale surfaces - regards
MP's with only net wrapping system
-
Film feed me
Time necessary during net (lm) feeding to get it an-
chored (hooked) between chamber and bale surfaces -
regards machine with alternave lm or net wrapping
-
Net revoluons
Number of net/lm wraps on bale in the chamber.
-
Feed roll closed delay
Connue to press the feed rollers together in mid posi-
on.
Knife delay
Delay on net/lm knife before cung.
Chamber open delay
Delay of opening the chamber aer net (lm) wrapping
completed
To Next Page
Loading...