ORKEL MP 2000 - Page 57

57
5.1.2- 
Check the condion of the tyres, they should have sucient tread depth and be without tears.
Control the tyre inaon and wheel nut torque before transport to a new locaon. See specicaons chap-
ter: 6.5 and 6.6
5.1.3- 
The chain -tension must be controlled and that the chains are supplied with sucient lubricant oil. Look for
abnormal wear and tear on gears and chains. Replace worn parts as needed.
Contact your local supplier or Orkel Compacon AS directly if you have any doubts about parts must be re-
placed.

Chain tensioner A:
Tighten the bolt unl there is a 3mm clearance on chain.
See picture to the right.

Unghten the bolts holding the bracket. Adjust the chain tension by
turning the nut on the bolt. Tighten the bolts holding the bracket when
the chain -tension is OK.

Chain tensioner B og C:
The length of the spring should be
between 130 - 140mm.

Increase the chain tension by ghten
the nut on the bolt.
(Picture to the right)
- 
Check out all the emergency switches is in perfect working order. Check the knife’s condion and its align-
ment with the rollers.
Chain tensioner B
Chain tensioner C
Chain tensioner A
3mm