– 42 –
2. To prevent the damage of monitor from leaked battery fluid, please
take out of battery if the monitor unused in a long time(generally more
than 3 months). If battery fluid should get in your eyes, immediately
rinse with plenty of clean water. Contact a physician immediately.
3. Attached battery is only for testing the function of the monitor,
Long-life alkaline batteries are recommended.
4. Dispose of the device, components and optional accessories
according to applicable local regulations. Unlawful disposal may
cause environmental pollution
5. Battery is dangerous stuff, do not mix it with other rubbish.
After you load the battery or connect power for the monitor, press
the Start/Stop button and hold it for more than 8 seconds, and then
you can start to set:
Initial user is User A, when the USER display is flashing, press the
memory button to choose the User A or B where the measuring data
will be stock in. Once the USER Setting is OK, press Start/Stop but-
ton to confirm.
when the YEAR display is flashing, press the me-
mory button, the year will increase by I year each, hold the memory
button and it will increase continuously 1 by 1, until 2099, once the
year Setting is OK, press Start/Stop button to confirm.
initial Month/Date is 1/01, when the Month
display is flashing, press the memory button, the month will increase
by 1, press Start/Stop button to confirm, and do in the same way to
set the date. Press Start/Stop button to confirm.
there is 2 mode for time 24-hours/ 12-hours, initial
mode is 24-hours, press memory button to set the time mode, when
you select 12-hours mode, time will display with AM and PM. Press
Start/Stop button to confirm. And the you can use same method to
set the time.
To Next Page
Loading...
