OROTIG Revo S Series User Manual

MAN00030-09-EN
LASER WELDER
L0F102HZ- L0F102HN- L0F200HZ - L0F200HN
This device has been designed in compliance with IEC EN 61010-1 and IEC EN 60825-1 safety standards to prevent injury to the
operator if used correctly and properly. However, no engineering design can make this device safe if it is not used and maintained
properly and in compliance with safety standards. This manual should be read carefully and in its entirety before performing any
operation. Failure to follow instructions and safety standards may cause injury to the operator and the device.

OROTIG Revo S Series Specifications

General

Brand	OROTIG
Model	Revo S Series
Category	Welding System
Language	English

Summary

Safety Information

General Safety Rules

Covers electrical, laser beam hazards, protective eyewear, and general precautions.

Safeguards

Emergency Stop & Access Control

Details the emergency button and enabling key/PIN for operation.

General & Transport Safety Rules

Installation

Transport, Unpacking, and Positioning

Electrical Connections & Tolerances

Requirements for power supply, outlets, and acceptable voltage/frequency variations.

Device Specifications

Technical Data and Standards

Detailed technical specifications for models and compliance with standards.

Intended Use and Improper Use

Specifies approved applications, materials, and prohibited actions.

Operator Interface

Controls, Components, and Connections

Identifies physical parts, their functions, and connection ports.

Use

Chamber Access and Display Operation

Startup, Emergency Stop, and Menus

Steps for powering on, using emergency stop, and navigating the stand-by menu.

Firmware, Settings, Check-up, and Operation

Maintenance

Regular Inspections

Coolant and Filter Maintenance

Alignment and Repair Procedures

Steps for checking, correcting alignment, and performing repairs.

Routine Maintenance and Liquid Handling

Diagnostics

Error and Warning Messages

Explains common error codes, warnings, and their solutions.