NOTE: THIS FAN ONLY NEEDS ONE SET
OF INPUT WIRES (black, white and ground
wire). Both of the fan and lights will be
controlled by the remote controller. The wall
switch is not able to control the fixture full func-
tionally.
THIS FAN CAN ONLY BE CONNECTED
ONTO ON/OFF SWITCH IF YOU HAVE ONE,
NOT SUITABLE FOR DIMMAER SWITCH.
Step 1. Install the Bracket
Take out the mounting bracket from the motor
housing by loosing the screws on the side. Se-
cure the bracket to the ceiling outlet box with
the screws and washers provided with your
outlet box (Fig. 1).
Step 2. Connect the Wires
Connect the black wire from the remote
receiver to your house live wire, white wire to
your neutral wire, bare copper/ green/ yellow
and green wire to your ground wire. Spread
the wires apart so that the live wires are on
one side of the outlet box and the neutral wires
are on the other side (Fig. 2).
Step 3. Attach the Ceiling Fan
Attach the ceiling fan to the mounting bracket
on the side of motor housing with screws pro-
vided (Fig. 3).
Step 4. Connect the LED Panel
Connect the wires from LED panel to the fan
housing with wire connectors. Attach the light
shade onto the blade cover by rotating clock-
wise (Fig. 4).
the bolt
(Fig. 6).
Step 5. Fix the downrod with set screws provided.
3. Hanging the Fan
Place the downrod ball into the bracket socket
(Fig. 7). Be sure the fixation slot is locked by the
bracket.
3. Installing the Fan
5
Fig. 1
Fig. 2
Fig. 3
Fig. 4
To Next Page
Loading...