Trouble Shooting
1. Fan doesn't work
• Make sure the fixture is connected to an ON/OFF wall switch, not dimmer switch.
• Check the remote control battery (not included in this package).
• Check the circuit breaker to ensure the power is on.
• Turn off power from the circuit breaker, then loosen the canopy and check all the
connections according to the wiring diagram.
2. Lights Do Not Light Up / Flicker / Noisy Operation
• Make sure the fixture is connected to an ON/OFF wall switch, not dimmer switch.
• Check your power and switch to make sure it's power on.
3. Noisy Operation
• Re-tighten all screws on bracket.
• Check to see if any of the blades are cracked. If so, replace the blades.
4. Remote does not work
• Make sure the battery is installed correctly.
• Pair the remote control again (See page 6).
• Install 2 new batteries.
Clean And Care
To clean, wipe the fixture with soft cloth. Spray from chemical cleaners can dis-
color the finish of the fixture. Do not use scouring pads, powders, steel wool or
abrasive paper to clean this fixture.
Ordering Parts
Keep this manual for future reference, and in case replacement parts are needed.
Available parts can be ordered from place of purchase. Use exact wording from
diagrams when ordering parts.
7
To Previous Page
Loading...