To Next PageTo Next Page
Need help?Do you have a question about the Orton AutoFire Plus and is the answer not in the manual?
General| Brand | Orton |
|---|---|
| Model | AutoFire Plus |
| Category | Controller |
| Language | English |
Guide to using the controller for preset cone programs.
Step-by-step instructions for firing to Cone 6 with adjustments.
Guide to creating and entering custom firing programs with 10 segments.
Steps to select and run stored custom user programs.
Instructions for modifying existing custom user programs.
Adjusts firing speed for preset programs to compensate for kiln load.
Review current firing cycle of preset cone or user programs.
Allows ending a hold or ramp and skipping to the next program ramp.
Adjusts firing temperature to match witness cones for preset programs.
Defines deformation temperature for selected cone numbers.
Sets an alarm for when the kiln reaches a specific temperature.
Controls vent fan operation based on programmed modes or user program segments.
Displays temperature difference between top and bottom thermocouples.
Exits options mode and returns to idle or run display.
Configure thermocouple types and view dual thermocouple readings.
Set node ID, lock programs, view model/serial/software info.
Configure alarm thresholds, number of relays, and middle zone power.
Display electronics temp and return from options menus.
Alarms triggered when measured temp differs from set-point by alarm value.
Alarm for slow heating rate and excessive firing time, aborts firing.
Includes threshold alarms and open thermocouple status.
Preset program for decals, lusters, and china firings, around Cone 019.
Preset program for earthenware and glazed bisque firings, around Cone 06.
Preset program for stoneware and porcelain firings, Cone 4-10.
Introduction to pyrometric cones for monitoring kiln behavior.
Details on how pyrometric cones bend and factors affecting their behavior.
Specifies available modes for vent fan operation (Off, On, OptA, OptB, Fn #).
Details the conditions for vent fan operation during increasing/decreasing ramps.
Explains how vent fan operation is controlled within user programs.
Diagrams showing thermocouple input block configurations for different models.
Provides color coding for Type K, N, and S thermocouples and their wires.
