Need help?Do you have a question about the Ortur Aufero Laser 1 and is the answer not in the manual?
Advice on when to upgrade or not to upgrade the firmware.
Essential prerequisites and preparations for a secure firmware update process.
Solutions for issues where the firmware fails to write to the motherboard.
Troubleshooting steps for errors caused by incorrect firmware file formats.
Instructions for downloading the correct firmware files from the official website on Windows.
Instructions for downloading the correct firmware files from the official website on MacOs.
Instructions for downloading the correct firmware files from the official website on Linux.
General| Laser Type | Diode Laser |
|---|---|
| Engraving Area | 400 x 400 mm |
| Connectivity | USB |
| Software Compatibility | LaserGRBL, LightBurn |
| Frame Material | Aluminum |
| Engraving Speed | 3000 mm/min |
| Connection | USB |
| Focus Mode | Fixed Focus |
| Cooling System | Passive Cooling |
| Power Supply | 12V 5A |
| Supported Materials | Wood, Acrylic, Leather, Fabric, Paper |
| Laser Wavelength | 445 nm |
| Input Voltage | 12V |
| Supported File Formats | BMP, JPG, PNG, SVG, DXF |
| Laser Power | 5.5W |
To Next Page
